Clutch Lever Free Play Inspection. Torque - Water Pump Cover Bolts: 11 N·m 1. This can damage or warp the disc. If a meter is left upside down or sideways for any length of time, it will malfunction. If the spring of either fork leg is shorter than the service limit, it must be replaced. If the measurement is under the service limit, replace the piston.
. An insufficiently tightened bolt or nut may become damaged or fall off, possibly resulting in damage to the motorcycle and injury to the rider. The push rod does not return to its original position once it moves out to take up cam chain slack. The initial maintenance is vitally important and must not be neglected. Rear Brake Light Switch 8.
If the bearing is removed, it will need to be replaced with a new one. The maxi- mum pressure is 123 kPa 1. If there is any doubt as to the condition of them, replace them with new ones. Rear Brake Switch Lead 3. If necessary, measure the oil level as follows. Valve Seating Surface Width 0.
If necessary, replace the gaskets with new ones. Connecting Rod Big End Bore Diameter Marks None: 41. Coolant on tires will make them slippery and can cause an accident and injury. Make sure the area is well-ventilated and free from any source of flame or sparks;. After disassembly and completely dry: 507 ±4 mL 17.
Right Hand Switch lead 4. Insert the hose till its white-painted mark 3. Al- though no adjustments are required, a thorough visual in- spection must be made at the intervals specified by the Pe- riodic Maintenance Chart. Wait until it cools down. . Coolant Filter Housing Set the coolant filter housing parallel to the outer side of the frame.
Clamp Right Hand Switch Lead, Throttle Cables, Brake Hose 6. Clutch Spring Free Length Standard: 34. Run the hoses inside the 2. Front Brake Light Switch 3. If the surface is corroded, or if the blades are damaged, replace the impeller. A tester other than the Kawasaki Hand Tester may show different readings.
Oil Pump Drive Gear T1: 11 N·m 1. . Torque - Alternator Cover Allen Bolt: 13 N·m 1. Run the hose below the 8. Place blocks under the wheel so that the disc does not touch the ground. Special tools, gauges, and Indicates a procedural step or work to be testers that are necessary when servicing done. Reserve Tank Over- mark right above.
Also, check to see that each cotter pin is in place and in good condition. This will burn out the diodes in the electrical parts. Wheelbase 1 595 mm 62. Torque - Coolant Drain Plug: 11 N·m 1. Refer to the ap- propriate chapters and Charging System Wiring Diagram.