Air filter element page 7-9 5. Check operation and free play. Lubricate all control cables and the pivoting points of all levers and pedals as well as of the center- stand. Apply Yamaha chain and cable lube or engine oil Control cables 10W-30 lightly. Install the brake shoe plate into the wheel hub as shown.
Do not operate the vehicle if you find any problem. Use of this information to perform service procedures is done entirely at your own risk. Yamaha continually seeks advancements in product design and quality. If there is play in the wheel ward and backward. In addi- dealer at the intervals specified in the tion, the cable should be lubricated at. Rust and corrosion can develop matte colored finished parts.
Yamaha dealer make the adjustment. This unit contains high- Operation of this motorcycle. Rear brake lever page 3-3 2. The fuel cock has two positions: S stop With the lever in this position, fuel will not flow. No trademark or patent liability is assumed with respect to the use of the information contained in this manual. Brake lever free play adjusting nut it falling over.
Remove the exhaust chamber bolt and washers. You can collide with another vehicle if you operate this vehicle on a public road. Spark arrester page 6-9 2. Chassis fasteners — Tighten if necessary. I searched all over the web and finally found you in Bing — sure glad I did! Improper tire pressure can cause loss of control. Kickstarter Starting a cold engine requires a richer To start the engine, fold out the kick- air-fuel mixture, which is supplied by starter lever, move it down lightly with. Whenever worn to the limit Check operation.
Front brake lever page 3-2 6. Consult a Yamaha page 3-6. Throttle grip 6-11, 6-16 If necessary, have Yamaha dealer adjust cable free play and lubricate cable and grip housing. You increase your risk of losing control if you carry a passenger. If proper adjustment cannot be ob- tained as described, have a Yamaha Front dealer make this adjustment.
Remove the exhaust manifold bolts, and then remove the ex- haust chamber. It is used to alert you to potential personal injury hazards. Do not attempt to diagnose such problems yourself. This manual should stay with this vehicle if it is sold. They contain important information for safe and proper operation of your vehicle. Vehicle Emission Control Information label 1. In not mix any chemical additives.
Dry the motorcycle with a chamois movers or inhibitors, brake flu- detergent, and a soft, clean sponge, or an absorbing cloth. Clean the surface of the spark plug plate is required. Obey all safety messages that follow this symbol to avoid possible injury or death. Never use on paved roads. To prevent damage or injury from sparking, make sure to ground the spark plug elec- trodes while turning the en- gine over. Rear shock absorber mounting bolt 2. Engine stop switch page 4-1 5.
While the instructions, photographs and illustrations in this manual have been reviewed for accuracy it is up to the individual performing the procedures to use good judgement when performing any procedures described. Starter choke lever page 4-7 3. Control cables 6-15 Lubricate if necessary. . Errors and Omissions If you notice any errors in this guide please contact us immediately. Therefore, while this manual contains the most current product information available at the time of printing, there may be minor discrepancies between your motorcycle.
If any free pair it. Make sure that operation is smooth. To check the operation should be checked before each ride, 1. Gasohol containing methanol is not recom- 1. Right handlebar switch page 3-1 5.